Aux In Socket; Backlight Timeout; Soft Mute (S-Mute); Setting Tuning Step - PERFECTPRO MYBOX 2 Mode D'emploi

AUX IN SOCKET

A 3,5mm Auxiliary input socket is provided on the radio to permit an audio signal to be fed into the unit
from an external audio device such as iPod, MP3 or CD Player.
. Remove the rubber cover, connect the audio source with a 3.5 mm audio connector wire.
2. Adjust the volume setting on your iPod, MP3 or CD player to ensure an adequate signal level from the
player, and then rotate the Volume Control on the radio as needed for comfortable listening.
Note:
When the audio source is connected, it will automatically mute the radio program you are listening.
Display will show 'AUX' when the audio source is connected.
Note:
Never use the Aux in socket in rainy or moist conditions to prevent moist from entering the radio. Always
keep the rubber cover well closed under these conditions.

BACKLIGHT TIMEOUT

Your radio allows you to adjust the length of time that the backlight stays on when you are not operating
your device.
This feature can be adjusted when the radio is on or off.
. Press and hold the Menu button to enter the setting
2. Rotate the Tuning control until "LIGHT" shows on the display. Press the Tuning control to enter the setting.
3. Rotate the Tuning control to select your desired backlight timeout option (0 seconds/20 seconds/30
seconds/remain backlight ON), then press the Tuning control to confirm the setting.
Note:
If you select backlight ON, the display backlight will remain illuminated when the radio is turned on, but
when the radio is switched off, the backlight will dim after 30 seconds.

SOFT MUTE (S-MUTE)

Soft Mute is to reduce background noise during weak signal, however it will also reduce radio reception.
The initial setting for Soft Mute is ON. Soft Mute can be set either radio is on or off.
. Press and hold the Menu button to enter the setting menu.
2. Rotate the Tuning control until "SOFTMUTE" is shown on the display. Press the Tuning control to enter
the setting.
3. Rotate the Tuning control to select "ON" or "OFF", then press the Tuning control to confirm the setting.

SETTING TUNING STEP

. Press and hold the Menu button to enter the menu setting.
2. Rotate the Tuning control until "FACTORY" shows on the display. Press the Tuning control to enter the
setting menu.
3. Rotate the Tuning control until 'FM X K' shows on the display. Press the Tuning control to enter the setting.
4. Rotate the Tuning control to choose the desired FM tuning step (50 kHz or 00 kHz). Press the Tuning
control to confirm the setting.
GB
8