Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DE
GB
INTRODUCTION
FR
It is compulsory to read this instruction manual before starting any
kind of action.
The proper operation and full compliance of this product's
NL
performance is guaranteed only if all the instructions provided in this
manual are closely adhered to.
ES
We guarantee that this product complies with the technical
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
IT
uses other than those described herein.
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PT
Misuse:
-
This product should only be used as described in this
PL
documentation; any other use is considered improper.
-
The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
DA
the equipment.
-
Moreover, misuse shall also void the warranty.
EL
Take care of your tools:
-
Be sure to store your tools in a clean state.
-
Place the tools inside their original package.
With the aid of the C-bracket and the optional matching pressure
pieces carrying joints, silent bearings, bushings and sleeves are
directly pressed on and out of the vehicle.
The tool is supplied with a trapezoidal thread spindle Tr27 and the
removal of the threaded adapter enables the retrofitting of the 16to
Mechadraulic spindle (fig. 2).
Both retainer adapters allow the direct removal from the pressure
plates from the "Universal tool set for the dismounting and mounting
of bushes, bearings and sleeves."
Optimal complement for Würth 1952 003 880 (fig. 3)!
Components
1 x C-bracket with threaded adapter AG 1-1/2"-16to TR27
1 x trapezoid thread spindle TR27x250mm
2 x retainer adapters for sleeve mounting plates.
TECHNICAL SPECIFICATIONS
Max. 200 ftlb - 300 Nm
6
METHOD OF PREPARATION
1
2
3
Publicité
Table des Matières
