Proper Use; General Description; Scope Of Delivery; Overview - Grizzly HUV 600-2000 Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27

Proper use

The device is suitable for removing un-
controlled growth between paving slabs,
on plastered surfaces, masonry, in flower
beds and lawn areas during growth pe-
riods, as well as for removing coats of
paint, for heating (for example, shrink tu-
bing), and for reshaping and welding pla-
stics. It can be used to loosen adhesive
joints, defrost water pipes and to ignite
grills. Any other use, or modification of the
device, constitutes improper use and po-
ses a considerable risk of accidents.
The manufacturer assumes no liability for
damage caused by improper use. The de-
vice is not intended for commercial use.
Note
Plants will not react immediately
to the radiant heat. The success of
actions using the device will not be
immediately visible.

General description

Scope of delivery

Carefully remove the device from the pa-
ckaging and check whether all the parts
listed below are present and complete:
-
Handgrip with extension rod
-
Housing with heating element
-
Surface nozzle
-
Grill lighter nozzle
-
Pull relief
-
Operating instructions

Overview

A
1 Handgrip with extension
2 Pull relief
3 Mains cable
4 Handgrip
5 Step switch
6 Air intake opening
7 Housing with heating element
8 Stand bracket
9 Surface nozzle
10 Grill lighter nozzle
11 Bayonet locking device
12 Blow-off pipe

Functional description

The device can be controlled with a step
switch. On level I, an air quantity of 500 l /
min at 50 ° C. is reached. On level II, the
device reaches an air quantity of 500 l /
min at 600 ° C.

Technical specifications

Hot air weed killer ............ HUV 600-2000
Motor input power ......................... 2000 W
Mains voltage ..............230-240 V~, 50 Hz
Safety class ......................................... II
Air quantity on level I .................. 500 l/min
Air quantity on level II ................. 500 l/min
Temperature on level I ......................50 °C
Temperature on level II ..................... 600 °
GB
13

Publicité

Table des Matières
loading

Table des Matières