Jump Starter Warnings - Wagan Tech Powr Dome NX Guide D'utilisation

Power Dome
™
3. Position the Power Dome so that you can see the Pressure Gauge.
4. Make sure the chuck lever is positioned UP (away from the chuck opening).
5. Remove the valve cap from the valve stem.
6. Attach the chuck to the tire's valve stem and move the chuck lever DOWN to secure the
chuck to the valve stem.
7. Turn compressor switch to the ON position.
8. Monitor the pressure gauge while inflating the tire.
9. When the recommended tire pressure has been reached, turn the compressor OFF.
10. Disconnect the hose and replace the valve cap.
11. Store the hose in the Air Hose compartment.
12. Recharge the Power Dome as soon as convenient.

JUMP STARTER WARNINGS

• CAUTIONS: Lead-acid batteries can release explosive gases. Failure to follow instructions
may cause property damage, explosion hazard and/or personal injury.
• This product is not a toy. Keep out of the reach of children.
• Do not smoke while using the jump starter.
• Make sure that someone is available to give assistance if needed.
• Do not operate this device while wearing vinyl clothing. Friction can cause static
electricity sparks. Remove any metallic jewelry, such as rings, bracelets, necklaces and
watches while working with a lead acid battery. It can produce a short-circuit that may
cause severe burns.
• Wear complete eye and clothing protection. Do not touch your eyes while working near
or with the battery.
• Keep battery terminals clean. Be careful to keep corrosion from coming in contact with
your eyes.
• Jump start vehicles or boats in well ventilated areas.
• Do not operate this unit submerged in or around water. Water can damage the unit.
• Do not let the cords of the jump starter or attached appliances get wet.
• This product is not intended for use in the rain or temperatures above 130° F.
• Never attempt to charge or jump start a frozen battery.
• To prevent short-circuits, power arcing, and/or explosions, never allow the metal ends/
tips of the black and red clamps (positive and negative terminals) to touch each other or
connect to the same piece of metal.
• After use, turn OFF the Power Safety switch.
• Excessive engine cranking can damage the vehicle's starter motor. If the engine fails to
start after the recommended number of attempts, discontinue the jump start procedure
and look for other problems that may need to be corrected.
11
NX by Wagan Tech
www.wagan.com
®