Jump Starting - Wagan Tech Powr Dome NX Guide D'utilisation

JUMP STARTING:

1. Review the Jump starter warnings.
2. Make sure all vehicle appliances, lights, radio, etc. are turned OFF.
3. Make sure the vehicle's brake is set and the transmission is in park.
4. Make sure all Power Dome switches are OFF.
5. Securely connect the Red (+) cable clamp to the vehicle's Positive (+) battery terminal.
6. Connect the Black (−) cable clamp to vehicle chassis or non-moving, metal vehicle
component.
* If the vehicle to be started has a Positive Grounded System (positive battery terminal is
connected to chassis):
A. Connect the negative (−) black clamp to the vehicle battery's negative terminal.
B. Connect the positive (+) red clamp to the vehicle chassis or a solid, non-moving,
metal vehicle component or body part. DO NOT clamp directly to the positive
battery terminal or moving parts.
7. Switch ON the Jumper Safety Switch located at the back of the Power Dome.
8. Inside the vehicle, turn on the ignition switch and attempt to start the engine.
9. Crank for a maximum of three seconds. If the engine does not start, wait three minutes
before the next attempt.
10. After the engine starts, turn OFF the Jumper Safety Switch.
11. Disconnect the Black Clamp first, and then disconnect the Red Clamp.
12. Be sure that the cables and clamps are securely stored.
13. Recharge the Power Dome as soon as convenient.
NOTE: If the engine does not start, there may be a problem other than a discharged battery.
Call for roadside assistance.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2013 Wagan Corporation. All Rights Reserved.
12