Usb Power Port; Am/Fm Radio - Wagan Tech Powr Dome NX Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. After use, disconnect the accessory plug from the Power Port
and store the accessory.
6. Replace the Power Port's dust cover and switch the DC/USB Power Switch to the OFF "O"
position.
7. Recharge the Power Dome as soon as convenient.

USB POWER PORT

1. Uncover the dust cover from the Power Port.
2. Turn the DC/USB Power Switch (next to the DC power port) to the ON "|" position.
Maker sure the LED next to the switch is lit.
3. Insert the USB plug into the Power Port.
4. Operate the appliance as usual.
5. After use, disconnect the USB plug.
6. Replace the Power Port's dust cover and switch the DC/USB Power Switch to the OFF "O"
position.
7. Recharge the Power Dome as soon as convenient.

AM/FM RADIO

The Radio can receive frequencies in the standard AM and FM broadcast bands (AM
520–1710 kHz, FM 88–108 MHz). An extendable rod antenna provides adequate signal to
receive all local radio stations. When not in use, the antenna should be stored in the retracted
position. This will prevent damage to the antenna while Power Dome is being moved. All Radio
controls are conveniently located in one area.
NOTE: All AM band radios are subject to receiving noise interference from electronic devices,
static lightning strikes and some motorized equipment. If you are operating the Power Dome
inverter and noise is being received on the AM band, either turn OFF the inverter or change
the radio to receive the FM band.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2013 Wagan Corporation. All Rights Reserved.
8

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2485

Table des Matières