Using The Power Inverter; Dc Power Port - Wagan Tech Powr Dome NX Guide D'utilisation

Power Dome
™
OFF switch. This fuse protects the inverter from an unlikely excessive power draw or short
circuit. Ordinary overloads will cause the inverter to automatically shut down. Reduce the load
and restart the inverter.

USING THE POWER INVERTER

CAUTION: Some rechargeable devices are equipped with a separate AC charger. These
devices are likely to operate properly with this inverter. Rechargeable devices that have built-
in chargers, on the other hand, may not be compatible with this type of inverter (see device
owner's manual).
Some motorized devices may operate at excessively elevated temperature when used with this
inverter. During first use with this inverter, check for excessive motor temperature. Abnormally
elevated temperature of the device is an indication that they should not be used with this
inverter.
1. Open the AC outlet dust cover.
2. Connect the AC appliance or appliances to either AC outlet.
3. Turn on the inverter by switching the Inverter's ON/OFF switch to the ON "|" position.
4. If the Inverter Power Indicator LED light is green, the inverter is operating.
5. Turn on one AC appliance and observe the Power Indicator.
• If the LED remains green, then turn on the second appliance.
• If the Power Indicator remains green, then both
appliances are operating properly.
• If the Power indicator LED is not lit, then reduce the AC load. If the
inverter is still not operating, refer to the troubleshooting table at the end of this
User's Manual.
6. After use, remove the appliances from the plugs.
7. Replace the Inverter dust covers and switch the Inverter Power Switch to the OFF "O"
position.
8. Recharge the Power Dome as soon as convenient.

DC POWER PORT

The DC Power Port (accessory socket) is located to the left of the Air Compressor Hose
Compartment. The port can power a DC load up to 11 Amps. Overloading the port results
in "tripping" the self-resetting circuit breaker. Removing the overload automatically restores
power to the DC power port.
1. Uncover the dust cover from the Power Port.
2. Turn the DC/USB Power Switch (next to the DC power port) to the ON "|" position.
Maker sure the LED next to the switch is lit.
3. Insert the 12V DC accessory plug into the Power Port.
4. Operate the appliance as usual.
7
NX by Wagan Tech
www.wagan.com
®