Power Dome
400 by Wagan Tech
™
3. Make sure nozzle lever is positioned up (away from the nozzle opening).
4. Remove the valve cap from the valve stem.
5. Attach the nozzle to the tire's valve stem.
6. Move the nozzle lever down to secure the nozzle to the valve stem.
7. Turn compressor switch on to "|" position.
8. Monitor the pressure gauge while inflating the tire.
9. When recommended tire pressure has been reached, turn the compressor
off to "O" position.
10. Disconnect hose and replace valve cap.
11. Store the hose in the Air Hose Compartment.
12. Recharge the Power Dome as soon as convenient.
DC TO AC POWER INVERTER
The Power Dome's inverter can operate most AC appliances or a combination of
appliances up to 400 watts. Operating time is dependant on the AC load (watts)
and the current charge of the Power Dome's internal battery. Reduced AC loads
and a fully charged battery will result in longer operating time. Be sure to turn off
or disconnect any AC appliance not in use.
There is a user-replaceable 40 amp automotive type fuse to the left of the inverter's
power switch. This fuse protects the inverter from an unlikely excessive input
current. Ordinary overloads will cause the inverter to automatically shut down.
When this happens, reduce the load and restart the inverter.
USING THE POWER INVERTER
1. Open the AC outlet dust cover.
2. Connect the AC appliance or appliances to either AC outlet.
3. Turn on the inverter using the inverter's power switch.
•
"|" = USB and DC sockets on
•
"O" = Off
•
"||" = Everything on (AC outlets, USB Port, and DC sockets)
4. If the Inverter Power Indicator light is green, the inverter is operating.
5. Turn on one AC appliance and observe the Power Indicator.
6. If the light remains green, then turn on the second appliance.
www.wagan.com
5
®
User's Manual—Read before using this equipment
7. If the Power Indicator remains green, then both appliances are operating
properly.
8. After use, remove the appliance plug and close the dust cover.
9. Recharge Power Dome as soon as convenient.
NOTES: If the Power Indicator light does not light up at all, reduce the AC
load. If the inverter is still not operating, refer to the troubleshooting table at
the end of this manual.
CAUTION:
Some rechargeable devices are equipped with a separate AC charger. These devices
will most likely operate properly with this inverter. Rechargeable devices that have built-in
chargers (see device owner's manual) may not operate properly with this type
of inverter.
The motors of some motorized devices may operate at excessive motor temperature.
Abnormally elevated temperature of the motor is an indication that they should not be used
with this inverter.
Some televisions and other electronics with sensitive components should be checked to see
if they are compatible with modified sine wave (non-sinusoidal) inverters. Check with the
appliance manufacturer.
JUMPSTART WARNINGS
Lead-acid batteries can release explosive gasses. Failure to follow instructions may
cause property damage, explosion hazard, and/or personal injury.
• This product is not a toy, keep out of the reach of children.
• Do not operate this device while wearing vinyl clothing. Static electricity
may be generated when vinyl clothing is rubbed.
• Remove any metallic jewelry, such as rings, bracelets, necklaces, and
watches while working with a lead acid battery. It can produce a short-
circuit that may cause severe burns.
• Wear complete eye protection. Do not touch eyes while working near or
with battery. Battery acid can cause blindness and/or severe burns.
• Do not smoke while jump starting.
• Never charge or jump-start a frozen battery.
• To prevent short-circuits and arcing, never allow the metal ends/tips of
clamps (positive & negative terminals) to touch each other or connect to
the same piece of metal.
• Power Dome is for use with 12 volt systems.
• Jump start a vehicle or boat in a well ventilated area.
©2012 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
6