Setting The Clock; Setting Radio Station Presets; 5Mm Audio Input; Using The Air Compressor - Wagan Tech Powr Dome NX Guide D'utilisation

SETTING THE CLOCK

1. With the radio off and the display showing in Clock Mode, tap the MEMORY button.
2. The clock display will flash and enter Clock Set Mode.
3. Tap the CH + button to increase the hour. Hold the button continuously to increase the
adjustment speed. The display will switch from AM to PM and PM to AM appropriately.
4. Tap the CH − button to increase the minutes. Hold the button continuously to increase the
adjustment speed.
5. Tap the MEMORY button again to confirm the new clock time, returning to regular Clock
Mode.

SETTING RADIO STATION PRESETS

The radio can hold up to 20 AM and 20 FM station presets in memory.
1. To record the current station as a preset, press and hold the MEMORY button for at least
1 second while the radio is playing on the desired station.
2. When the "M" on screen flashes, tap the "CH+" or "CH−" button repeatedly to select the
desired memory position between 1–20.
3. Press and hold the MEMORY button once more to confirm the station preset at that
position. The radio will switch back to regular Radio Mode.
4. Repeat steps 1 to 3 for each desired preset.
5. To select a preset station, tap the MEMORY button. The preset station will display on the
LCD screen with "M" and the preset number 1–20.
3�5MM AUDIO INPUT
1. Turn the radio on.
2. Insert a 3.5mm audio cable into the audio input jack.
3. The opposite end of the cable should be plugged into a compatible audio device.
4. Turn on the audio device and set it to output sound. The sound should be audible from the
Power Dome speakers.
5. The Power Dome's USB Power Port can conveniently power your audio device.

USING THE AIR COMPRESSOR

The Air Compressor can inflate a variety of tires and inflatable equipment. It can provide
inflation pressure up to 260 PSI (pounds per square inch). Be careful not to over-inflate by
monitoring the compressor gauge while inflating. The Compressor's ON/OFF switch is located
above the compressor hose and nozzle compartment.
CAUTION: Never connect or disconnect the nozzle with the compressor operating.
1. Before inflating any tire, look for the recommended inflation pressure information on the
inside of the car door.
2. Open the compartment door on the side of the Power Dome and extend the hose.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2013 Wagan Corporation. All Rights Reserved.
10