Work Light; Using The Hazard Flasher - Wagan Tech Powr Dome NX Guide D'utilisation

WORK LIGHT

The Work Light is a cluster of bright LEDs located at the front of the Power Dome. The location
of the Work Light allows the light to be used while the Power Dome is being carried.
1. Turn the Light Switch (located below the Pressure Gauge and Voltmeter) to the Work Light
"|" position.
2. The light will illuminate.
3. Turn OFF while not in use.

USING THE HAZARD FLASHER

The Hazard Flasher Lens turns the Power Dome light into a caution warning for passing traffic.
1. Attach the red Hazard Flasher Lens Cover over the light snugly.
2. Switch the light on to Blinking mode by selecting "||" on the Light Switch.
3. Place the Power Dome in a spot easily noticed by other vehicles.
Attach Hazard Flasher Lens to Light
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2013 Wagan Corporation. All Rights Reserved.
Switch to Blinker Mode
14