Operating; Maintenance And Cleaning - EUROM 1502 Mode D'emploi

The following applies to both methods
 Run the electrical cable along the hanging chain
and secure at multiple points with a tie-wrap.
The first tie-wrap must be secured to the third
link as the first few links become hot. Make
sure that the cable is tight along the chain but
do not hang the device on the cable! Run the
electrical cable from the (hot) party-tent heater
to a socket.
 Your party-tent heater is now ready for use.

Operating


Insert the plug into the socket. Check beforehand whether this socket meets the
requirements indicated on the party-tent heater's specification plate, i.e. 220-
240V / 50Hz.
Partytent-heater 1502

Pull on the pull-cord once. The lamp will come on and the indicator light will
come on. The partytent-heater will emit 750W of heat.

After pulling on the cord again the heater will emit 1500W of heat.

Pulling on the pull-cord again will switch the party-tent heater off. These settings
will be repeated if you continue to pull the cord.
Partytent-heater 2100

Pull on the pull-cord once. The smaller, lower lamp will go on and the
corresponding indicator light will come on. The party-tent heater will emit 900W
of heat.

Pulling on the cord again will switch on the larger, higher lamp (1200W). The
corresponding indicator light will come on.

Pulling on the pull-cord for a third time will switch on both lamps. Both indicator
lights will now come on and the heater will emit 2100W of heat.

Pulling on the pull-cord for a fourth time will switch the party-tent heater off. The
lights will go out.

These four settings will be repeated if you continue to pull the cord.
The following applies to both types

The party-tent heater is not equipped with a thermostat and will continue to emit
heat for as long as it is switched on. Never leave a functioning party-tent heater
unsupervised!

Remove the plug from the socket once the lights have gone off if you wish to
turn the device off.

Maintenance and cleaning

Switch the device off, remove the plug from the socket and leave to cool before
performing maintenance or cleaning.
14