j Be particularly careful when car
rying out a „plunge cut" into an
existing wall or an area you can't
see into. The plunging disc may
cut into gas or water pipes, elec-
trical cables or other objects and
cause kickback.
6 – Safety instructions
relating specifically to
the equipment
• The device is suitable for dry cuts
only, without the use of water.
• Only use the wall chaser with the
additional handle!
• Check the area you intend work-
ing on for power lines, water and
gas pipes.
• Do not use tools that require a liq-
uid cooling agent. The use of water
or other liquid cooling agents may
lead to electrical shock.
When working with a wall chaser, a
lot of dust is generated. Thus, never
work without dust extraction and
always wear a dust protection mask!
• If the power cable is damaged, it
must – in order to prevent risks –
be replaced by the manufacturer
or their customer service repre-
sentative.
Safety notes for the laser marking
aid
• Caution! If methods of operation
and adjustment other than those
described in the operating instruc-
tions are used or other procedures
carried out, this may result in haz-
58
ardous laser beam related effects.
5459200-Mauernutfraese_man.indd 58
5459200-Mauernutfraese_man.indd 58
• The power tool is supplied with
warning signs. These must be
applied in accordance with Figure 9
• Do not look into the laser beam.
Looking into the laser outlet from a
distance of 100 mm with optical
instruments (e.g. magnifying glass or
microscope) may cause a risk of
damage to the eyes.
• Never point the laser beam
towards people or animals.
• Never use the laser beam on very
reflective materials. There is a risk
posed by the reflected light.
• Have repairs to the laser projector
carried out by specialists only.
• Do not introduce hard objects into
the laser optic (15).
• Clean the laser optic with a soft,
dry brush.
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
„Tested Safety" voluntary
quality mark
Housing is double insulat-
ed
CE Mark (conformity to
European safety stand-
ards)
Caution laser beam! Do
not look into the beam!
06.07.20 08:50
06.07.20 08:50