Philips S99 Série Mode D'emploi page 28

ENGLISH
28
4 Clean the cutter and guard under the tap.
5 After cleaning, place the cutter back into the guard.
6 Put the shaving heads back into the shaving head holder.
Note: Make sure the notches on both sides of the shaving heads
fit exactly onto the projections in the shaving-head holder.
7 Place the retaining ring holder on the retaining
ring (1), place it on the shaving head (2) and turn it
clockwise (3) to reattach the retaining ring.
Repeat this process for the other retaining rings.
Note: Hold the shaving head holder in your hand when you
reinsert the shaving heads and reattach the retaining rings.
Do not place the shaving head holder on a surface when you
do this, as this may cause damage.
8 Reattach the shaving head holder to the bottom part
of the shaving unit.