Step 6: Backguard Installation - Thermador PCG304G Manuel D'installation

Step 6: Backguard Installation

Low Back and Flush Island Trim Model Numbers
Rangetop 12" Low Back
Size (sold separately)
30" PA30GLBC
36" PA36GLBC
48" PA48GLBC
For island installations and other installations with over 12"
(305 mm) clearance, the included Flush Island Trim may be
used. A Low Back guard must be installed when there is
less than a 12" (305 mm) clearance between combustible
materials and back edge of cooktop. (See Figure 1 and
Figure 5.) Clearances from non-combustible materials are
not part of the ANSI Z21.1 scope and are not certified by
CSA. Clearances of less than 12" (305 mm) must be
approved by the local codes and/or by the local authority
having jurisdiction.
English 12
Flush Island Trim
Included with rangetop
Included with rangetop
Included with rangetop
c.) Slide backguard
over support brackets
& secure with 8 x
1½" (38 mm) screws
b.) Install support
brackets with 8 x 1½"
(38 mm) screws
a.) Remove Flush
Island Trim
Attach the backguard before sliding the appliance into the
final installed position. Follow Steps A through E below:
a. Depending on model, remove the 2 or 3 stainless Torx
screws in the front face of the included Flush Island
Trim. Lift up to fully remove the Flush Island Trim (A,
Figure 12).
b. Slide the support brackets between the two rangetop
chassis back panels. Secure each bracket with 4 x 1½"
(38 mm) screws (B, Figure 12).
c. Slide backguard over the two brackets on the rear of
the rangetop. Fasten them together with 8 x 1½"
(38 mm) screws (C, Figure 12).
d. Fasten the front of the backguard to the rangetop with
2 or 3 x ½" (12.7 mm) screws (D, Figure 12).
e. Place the backguard cap on top and secure using 2 x
½" (12.7 mm) stainless screws (E, Figure 12).
e.) Fasten cap
with 2 x ½"
(12.7 mm) screws
d.) Secure front with
½" (12.7 mm)
stainless screws
Figure 12: Low Back Attachment