Others - Pioneer BDP-440 Mode D'emploi

BDP-140_UCXCNSM_IBD_EN.book Page 59 Tuesday, July 19, 2011 10:54 AM
Problem Check
A message other than Is "Network is FAILED."
"Networks is OK." is displayed?
displayed when Connection
Test is performed.
Is the Ethernet hub (or router
with a hub functionality)
operating properly?

Others

Problem Check
The player's power turns off Is Auto Power Off set to 10
automatically. min/20 min/30 min?
The player's power turns on Is Control set to On?
automatically.
The player cannot be Are you operating the remote
operated with the remote control from a point too far
control. away from the player?
Are the batteries dead?
Input of the connected TV Is Control set to On?
and AV system switches
automatically.
Settings I have made have • Have you disconnected the
been cleared. power cord while the player's
power was on?
• Has there been a power
failure?
Remedy
• Check that this player and the Ethernet hub (or router with a hub
functionality) are properly connected.
• If the IP address is obtained using the DHCP server function, check
the setting is correct at the IP setting (page 42). For details on the
DHCP server function, see the operating instructions for the Ethernet
hub (or router with a hub functionality).
• Set the IP address manually.
• Check the operation and settings of the DHCP server function of the
Ethernet hub (or router with hub functionality). For details on the DHCP
server function, see the operating instructions for the Ethernet hub (or
router with a hub functionality).
• If this player has been set manually, reset the IP address of this player
or other components.
• Check the settings and operation the Ethernet hub (or router with a
hub functionality). For details, see the operating instructions for the
Ethernet hub.
• Reboot the Ethernet hub (or router with a hub functionality).
Remedy
If Auto Power Off is set to 10 min/20 min/30 min, the player's power
turns off automatically if no operation is performed for over 30 minutes
(page 43).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set Control to Off
(page 41).
Operate from within 7 m of the remote control sensor.
Replace the batteries (page 6).
The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Home
Media Gallery, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set Control to Off (page 41).
Always press  STANDBY/ON on the player's front panel or
 STANDBY/ON on the remote control and check that POWER OFF
has turned off from the player's front panel display before
disconnecting the power cord. Be particularly careful when the power
cord is connected to the AC outlet on another device because the
player turns off in conjunction with the device.
08
59
En