Others - Pioneer ELITE BDP-62FD Mode D'emploi

08
Problem
A message other than
"Networks is OK." is
displayed when Connection
Test is performed.

Others

Problem
Power does not turn on.
The player's power turns off
automatically.
The player's power turns on
automatically.
This unit cannot be operated.
The player cannot be
operated with the remote
control.
Input of the connected TV
and AV system switches
automatically.
Settings I have made have
been cleared.
54
En
Check
Is "Network is FAILED."
displayed?
Is the Ethernet hub (or router
with a hub functionality)
operating properly?
Check
Is the power cord properly
connected?
Is Auto Power Off set to 10
min/20 min/30 min?
Is Control set to On?
Are you operating the remote
control from a point too far
away from the player?
Are the batteries dead?
Is Control set to On?
• Have you disconnected the
power cord while the player's
power was on?
• Has there been a power
failure?
Remedy
• Check that this player and the Ethernet hub (or router with a hub
functionality) are properly connected.
• If the IP address is obtained using the DHCP server function, check
the setting is correct at the Information (page 40). For details on the
DHCP server function, see the operating instructions for the Ethernet
hub (or router with a hub functionality).
• Set the IP address manually.
• Check the operation and settings of the DHCP server function of the
Ethernet hub (or router with hub functionality). For details on the DHCP
server function, see the operating instructions for the Ethernet hub (or
router with a hub functionality).
• If this player has been set manually, reset the IP address of this player
or other components.
• Check the settings and operation the Ethernet hub (or router with a
hub functionality). For details, see the operating instructions for the
Ethernet hub.
• Reboot the Ethernet hub (or router with a hub functionality).
Remedy
• Plug the power cord securely into the power outlet (page 21).
• Unplug the power cord, wait several seconds, then plug the power
cord back in.
If Auto Power Off is set to 10 min/20 min/30 min, the player's power
automatically turns off if no operation is performed for the set amount
of time (page 41).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set Control to Off
(page 40).
• Use within the specified usage temperature range (page 57).
• If the power cannot be turned off (to standby), reset the unit. Press
and hold  STANDBY/ON on the main unit's front panel for over 5
seconds.
Operate from within 23 feet (7 m) of the remote control sensor.
Replace the batteries (page 6).
The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Home
Media Gallery, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set Control to Off (page 40).
Always press  STANDBY/ON on the player's front panel or
 STANDBY/ON on the remote control and check that POWER OFF
has turned off from the player's front panel display before
disconnecting the power cord. Be particularly careful when the power
cord is connected to the AC outlet on another device because the
player turns off in conjunction with the device.