Getting Started; Making Settings Using The Setup Navigator Menu - Pioneer BDP-440 Mode D'emploi

BDP-140_UCXCNSM_IBD_EN.book Page 24 Tuesday, July 19, 2011 10:54 AM
Chapter 3
03

Getting Started

Making settings using
the Setup Navigator
menu
Be sure to perform these settings when using the player
in the following situations.
• When you use the player for the first time.
• After Initial Setup format.
• After updating the player's software.
Caution
• Before turning on the power, check that the
connections between the player and other devices are
correct. Also, turn on the power of the devices
connected to the player before turning on the player's
power.
• When using a Pioneer Flat Screen TV or front
projector compatible with the Control function, set
Control to On on the connected device before turning
on the player's power.
Note
• When a Pioneer Flat Screen TV or front projector
compatible with the Control function is connected to
the player using an HDMI cable, the player is
automatically set to the optimum picture quality for
the connected device.
1 Turn on the TV's power and switch the input.
See the TV's operating instructions for the details of
operating the TV.
2 Turn on the player's power.
Press  STANDBY/ON.
Check that the Setup Navigator menu is displayed.
 If the Setup Navigator menu is not
displayed
 Press
HOME MENU to display the Home
Menu, select Initial Setup  Setup Navigator 
Start, then press ENTER.
24
En
3 Start Setup Navigator.
Press ENTER.
• Setup Navigator starts.
4 Select the OSD language.
Use / to select, then press ENTER.
When a Pioneer Flat Screen TV that is compatible with
Control function is connected to this player's HDMI OUT
terminal, language settings are imported from the
Pioneer Flat Screen TV's language settings before Setup
Navigator begins.
5 Select the appropriate output resolution for the
connected TV.
Use / to select, then press ENTER.
6 Select the appropriate aspect for the connected
TV.
Use / to select, then press ENTER.
7 Close the Setup Navigator menu.
Press ENTER.
• Setup Navigator finishes and the setting is stored.
• Press RETURN to go back to the previous
screen.