On Power Sources - Sony SU-B551S Mode D'emploi

Masquer les pouces Voir aussi pour SU-B551S:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
• Do not coil the AC power cord (mains
lead) around the AC adapter (mains
adaptor). The core wire may be cut
and/or it may cause a malfunction of
the TV.
• Do not touch the AC adapter (mains adaptor) with wet
hands.
• If you notice an abnormality in the AC adapter (mains
adaptor), disconnect it from the AC power outlet (mains
socket) immediately.
• The set is not disconnected from the AC (mains) source as
long as it is connected to the AC power outlet (mains
socket), even if the set itself has been turned off.
CAUTION
If the following precautions are not observed,
injury or property damage may occur.
Do not install any equipment other
than the specified product.
This TV Stand is designed for use with the specified product
only. If you install equipment other than specified, it may fall
or break, and cause injury. Illustrations used in this manual
show of the KDL-40NX72x, unless otherwise stated.
Be sure to secure the TV.
Secure the TV to the TV Stand using the supplied screws. If
the TV is not installed securely, it may fall, or the TV Stand
may topple over, and cause injury.
Notes on installation
Do not allow the TV Stand to be installed at an angle or
incline. To avoid this, observe the following precautions.
– If you install the TV Stand on a soft surface such as a
mat or a carpet, lay a board over the designated location
beforehand.
– Do not install the TV Stand in a place subject to direct
sunlight or near a heater.
– Do not install the TV Stand in a hot or humid place, or
outdoors.
Note on use
Cleaning
To keep the TV Stand clean, occasionally wipe it with a dry
soft cloth. Stubborn stains may be removed by wiping with a
cloth slightly dampened with mild soap. Be sure to dry the
area afterwards with a dry soft cloth. Do not use chemicals,
such as thinner or benzine, as they damage the finish of the
TV Stand.
4
(GB)
Be sure that two or more persons do
the installation work.
Be sure that two or more persons install the TV on the TV
Stand. If one person does the installation work alone, this
may result in an accident or injury.
Do not modify the TV Stand.
It may fall and cause injury.
Be sure to install the TV securely
following the instructions.
Tighten the screws securely. If the TV is not installed
securely, it may fall and cause injury.
Be careful not to injure your hands
or fingers while assembling.
• Do not move the TV Stand with holding the Neck section.
• Be careful not to hurt your fingers or hands when
installing the TV.
PRECAUTIONS

On power sources

• If you are not going to use the TV Stand for a long time, be
sure to disconnect the TV Stand from the wall outlet
(mains). To disconnect the AC power cord (mains lead),
grasp the plug itself; never pull the cord.
• AC power cord (mains lead) must be changed only at the
qualified service shop.
On operation
Before connecting other components, be sure to turn off and
unplug the TV Stand.
Copyrights
This TV Stand incorporates Dolby
Surround and the DTS
**
Digital Surround System.
* Manufactured under license from Dolby Laboratories.
Dolby, Pro Logic, and the double-D symbol are trademarks of
Dolby Laboratories.
** Manufactured under license under U.S. Patent #'s:
5,451,942; 5,956,674; 5,974,380; 5,978,762; 6,487,535 & other
U.S. and worldwide patents issued & pending. DTS and the
Symbol are registered trademarks & DTS Digital Surround and
the DTS logos are trademarks of DTS, Inc. Product includes
software. © DTS, Inc. All Rights Reserved.
This TV Stand incorporates High-Definition Multimedia
Interface (HDMI™) technology.
HDMI, the HDMI Logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing LLC in the United States and other countries.
*
Digital and Pro Logic

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Su-b461sSu-b401s

Table des Matières