Operating Times - Wolf Garten Concept 43 BPP Mode D'emploi

Safety Instructions
5. fter working:
• The throttle should be closed before switching off the engine. If the engine is equipped with a petrol shut-off valve then this be closed after mowing has
been completed.
• Do not leave the mower in closed areas after switching off - allow it to cool off in the open air before storing away.
• Never keep the machine with petrol in the tank within a building in which gasoline vapours may possibly come into contact with naked flames or sparks.
Before leaving the mower remove the spark plug lead and - if fitted - the starting key.
• Lifting and carrying the mower for transport:
• Never attempt to lift the mower with the engine running - nor with a hot engine - always remove the spark plug lead before lifting or carrying.
• When folding the mower handlebars, detach starter cable and make certain that the control cables are not snagged or stretched when folding or
unfolding.
• lways carry out the engine oil change with the fuek tank empty anf filler cap fitted. Th engine should be warmed up prior to draining the oil to ensure all
sludge deposits are drained away with the oil.
6. Maintenance
• Regularly examine all fixing bolts and nuts, particularly those of the cutter bar, for tightness.
• Maintenance and cleaning of the equipment as well as removing the protection device may only be performed with the engine stopped and the spark plug
lead and - if available - the starting key, removed. Note information on the chassis before cleaning and oil change!
• Make certain that all nuts, pins and screws are firmly tightened and that the unit is in a safe operating condition.
• In order to avoid the risk of fire keep the engine, exhaust, battery box and the area around the fuel tank free of grass, leaves or oil.
• If the equipment must be tilted for maintenance work then the fuel must be completely drained from the tank beforehand.
• Clean the equipment after each use with a hand-brush - not with water and do not hose down with a high pressure hose in particular. Make certain to keep
the engine cooling fins and engine cooling air intake clean and free from debris.
• Do not place the equipment in damp areas, near naked flames or where a spark might ignite petrol vapour.
• If the fuel tank is to be emptied then this should be done outdoors. Make sure that no fuel is spilled.
• For safety reasons replace worn out or damaged parts.
• NOTE! lways have blades replaced or sharpened by a WOLF Service Centre, as a blade balance test must be performed in accordance with safety
regulations and the blade retaining bolt must be tightened to a specified torque.
• Wear suitable work gloves when carrying out the above work, especially when handling the blade.

Operating Times

Please convider the individual country spezification.
ssembly
Fixing of handle and adjustment of height (fig. M1/M2/M3)
TTENTION! Take care that theswitch cable does not become caught and crused when folding the handle frame.
Fold upper handle sction forward. Tighten hand wheels firmly (M1/M2, 1). Fold complete handle backwards, position at the correct
height and tightem firmly (M2/M3).
Folding of Handle frame (fig. M3)
C UTION! The Bowden cables must not be crushed when folding or unfolding the handlebar.
Unscrew the lower hand wheels (2) for about 2 cm/1" either side, pull handle frame (3) either side, pull handle frame clear of
recesses until it can be foded forward easily.
Starter cord assembly (fig. B9)
Lift and hold safety bar (B7/B8, 3). Pull the starter cord slowly to the holding bracket, and twist the cord through the holder (as
Muster). lways remove the starter cord from the holder before folding the mower handles.
Grass catcher (fig. M4)
Operation
Oil Fill (fig. B1)
Fill crankcase with quality oil HD S E 15-W40 up to the marking "Full" on dipstick. (Do not exceed mark.) Capacity approx. 0,6 litre.
Lift mower slighly on the oil filter side whilst pouring oil slowly.
Screw in dipstick according to illus.
Filling with Petrol (fig. B2)
Do not smoke - no open fire!
Switch off engine. void spilling petrol when engine is warm. Use "low-octane pet-rol" (do not use Super Plus).
void petrol spillage. Do not inhale vapour.
Fit catcher bag (fig. B3)
Lift deflector lid, locate grassbox hook into opening of chassis (see arrow) and replace lid.
Use of heigth adjustment (fig. B4)
Only when mower is stationary and rotating blade has come to complete standstill.
Pull lever and move forward or backward. Engage into chosen position (2,0; 3,0; 4,0; 5,0; 6,5; 8,0 cm).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do not se cutting position too low when mowing very hight or wet grass.
We recommend an average cutting height of 4,0 cm.
Starting (fig. B5/B6/B7/B8/B9)
1. Place mower on level ground, not ontohigh grass.
2. POWER position: press red notch button (B5,1) and move the gas lever to the perceptible stop of the POWER position (B5, 2).
3. Firmly press the primer on the engine three times (B6).
4. Raise and hold safety grip (B7/B8, 3).
B, check oil level.
10