Operating Times - Wolf Garten Premio 40 EA Mode D'emploi

Safety Instructions
6. Maintenance:
- Switch off motor and remove mains plug before carrying out any repairs or maintenance to your mower;
- Do not clean yor mower with a hose pipe - and particularly not with a high-pressure spray;
- Inspect regularly all visible nuts and bolts - particularly ot the cutter blade - for their tightness;
- TTENTION! Sharpening and changing of cutter blades should be done by a qualified service centre because it is necessary that the
correct
balance after fixing is guaranteed;
- Damaged and worn parts must always be replaced with original WOLF replacement parts as otherwise your guarantee will be invalidated;
- Your service centre should check your mower regularly and particularly after any hard obstacle hat hit the chassis and/or the cutter blades;
- Store your mower only in a dry room.
- If cutter blade hits a hard foreign object whilst mowing switch of motor immediately, remove safety key and check cutter blade carefully for
damage.

Operating Times

ccording to law in some countries lawn mowing not allowed on Saturdays and Sundays and at certain other times (eg. at midday
or after 7 p.m.). Please check noise abatement regulations prevailing in your country.
ssembly
Fixing of handle and adjustment of height (fig. M1/M2/M3/M4)
TTENTION! Take care that the switch cable does not become caught and crused when folding the handle frame.
Fold upper handle section forward. Tighten hand wheels firmly M1/M2. Fold complete handle backwards, position at the correct
height and tightem firmly M3/M4.
nti-kink protection(fig. M5)
IMPORT NT! The cable must always lie in the anti-kink protector.
ssembly of cable relief holder (fig. M6/M7)
Folding of handle frame (fig. M8)
TTENTION! Take cara that the switch cable does not become caught and crushed when folding the handle frame.
Note! Unscrew the lower hand wheels (1) for about 2 cm/1" either side, pull handle frame (2) either side, pull handle frame clear
of recesses until it can be folded forward easily.
Connecting to the mains (230 Volts, .C., 50 Hz)
The mower operates from any normal household mains supply, provided with a 13 mps. fuse. Note: Use a residual current
device (RCD) rated for a residual current not greater than 30 m .
Operation
ttaching of grassbox (fig. B1)
Lift deflector lid, locate grassbox hook into opening of chassis (see arrow) and replace lid.
Use of heigth adjustment (fig. B2)
Only when mower is stationary and rotating blade has come to complete standstill.
Place hand into handle bar and depress button. Lift or lower chassis until it engages into required position (see indicator).
Selection of cutting height
If possible, mow when grass is dry in order to protect turf. Do not se cutting position too low when mowing very hight or wet grass.
We recommend an average cutting height of 4,5 cm.
Switch-on motor - Premio 40 E/46 E (fig. B3/B4)
Switch on motor with mower placed on level and firm ground, not in high grass - alternatively tilt slightly (fig. B3).
Depress button and hold B4 (1). Lift up bar B4 (2) and release button B4 (1). Switch-off motor: Release bar B4 (2).
Switch-on motor - Premio 40 E /46 E (fig. B3/B5)
Switch on motor with mower placed on level and firm ground, not in high grass - alternatively tilt slightly.
Depress button and hold B5 (1). Lift up left bar B5 (2) and release yellow button B5 (1). Drive on: Lift right bar after motor runs at
full speed. Set speed: 1st gear B5 (4) = slow (2 km/h). 2nd gear B5 (5) = fast (4 km/h). Switch-off drive: Release right bar B5 (3).
Switch-off motor: Release left bar B5 (2).
Mowing (fig. B6)
lways let cable trail on the cut side of the lawn. Cable guidance: Place the cable firmly off the lawn or on the already cur
side of the lawn when starting to mow.
Turning (fig. B7)
The cable relief holder enables you to move the cable from one side of the handle frame to the other. Thus you ensure that the
cable always trails on the ride of the lawn already cut-and not in front of the machine.
Emptying of grassbox (fig. B8)
Only when mower is stionary and rotating blade has come to complete standstill.
Box filling indicator: The flap drops down when grassbox is full. To ensure properfunctioning of the indicator it is important that the
grilles below are kept clean using a hand brush.
11