Aqua Clean Function - Pelgrim OVM416 Mode D'emploi

CLEANING

Aqua Clean function

Aqua Clean function
EN 20
slightly (to marker 1 on the bracket) and pull this away from the
glass slightly (to marker 2 on the bracket).
2. Grasp the glass at the bottom and gently lift this upwards to
remove it from the support.
3. The inner third glass (depending on the model) can be removed by
lifting this carefully and removing it. Also remove the rubber seals
around the glass.
To replace the glass pane, observe the reverse order. The markings
(semicircle) on the door and the glass pane should overlap.
With the Aqua Clean function and a damp cloth, you can easily remove
grease and dirt from the oven walls.
Using the Aqua Clean function
Only use the cleaning programme if the oven is cold. If the oven is hot,
it is more difficult to remove dirt and grease using this programme.
1. Remove all accessories and guide rails from the oven.
2. Pour approximately 0.15 litres of water into the bottom of the empty
oven.
3. Turn the 'oven function dial' to 'Aqua Clean'.
4. Set the temperature at 70 °C and the time at 30 minutes.
Food remains on the enamel walls will be sufficiently soaked after
30 minutes so that they can be removed with a damp cloth.
Please note: It is not possible to change the length of the cleaning
programme during cleaning. Turn the 'oven function dial' to position '0'
to interrupt the cleaning programme.