Tig Comfort-Stop Parameter (For The Tig Welding Process) - Fronius TransPocket 1500 Instructions De Service

"Characteristic"
parameter (for
the rod-electrode
welding process
with CEL electro-
des)
(continued)
TIG comfort-stop
Important! The "TIG comfort-Stop" parameter is only available on the TP 1500 TIG
parameter (for
power source.
the TIG welding
process)
The TP 1500 / TP 1500 RC power sources behave the same way at the end of welding
as does the TP 1500 TIG when the TIG comfort-stop function is deactivated.
The "TIG comfort-stop" parameter is for setting the TIG comfort-stop function.
Important! The setting made for the TIG comfort-stop parameter will also apply to the
"TIG pulsed-arc welding" process (10) (TP 1500 TIG only).
The setting made for the TIG comfort-stop parameter determines how much longer the
arc will briefly need to be made in order to trigger the TIG comfort-stop function.
If the welding operation is often being stopped unintentionally, set the TIG comfort-stop
parameter to a higher value
- Stage 0 ................ TIG comfort-stop function is deactivated
- Stage 1 ................ TIG comfort-stop function is initiated when the arc length is
- Stage 3 (4) .......... TIG comfort-stop function is only initiated once the arc length is
TP 1500 TIG
4 A/V (factory setting)
3 A/V
2 A/V
1 A/V
0 A/V (no LED = constant
current)
increased only very slightly and is shortened presently
increased very considerably and is shortened presently
On TP 1500 TIG, function is initiated by shortening the arc length
when first:
the arc length is increased very considerably
the arc length is increased considerably
the arc length is increased slightly
the arc length is increased very slightly
deactivated (factory setting)
TP 1500 / 1500 RC
-
4 A/V (factory setting)
2.7 A/V
1.3 A/V
0 A/V (no LED)
1 8