Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16 Progress
Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar. If
not, the dirt can cause damage to the
hob. Take care to avoid burns. Put the
special scraper on the glass surface at
an acute angle and move the blade on
the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem
You cannot activate or oper-
ate the hob.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Make sure, you
operated the hob correctly. If not the
INSTALLATION
WARNING! Refer to Safety
chapters.
Hob and oven connection type
This appliance has an orange 1x14 pole
connector and can be connected to an
oven with an orange 1x14 pole connector.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
• Remove shiny metallic discoloration:
use a solution of water with vinegar and
clean the glass surface with a moist
cloth.
Possible cause
The fuse is blown.
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
Remedy
Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
Publicité
Table des Matières
