DeWalt DW078 Guide D'utilisation page 12

REMOTE CONTROL: POWER BUTTON
Press the remote control power button (G) to put the laser unit into
Sleep Mode. In Sleep Mode all laser unit functions shut off except
for a periodic blink from the power LED (D) on the control panel of
the laser unit. Press the remote control power button again to "wake
up" the laser unit.
NOTE: To completely power the laser unit off, the power button
on the control panel of the laser unit must be pressed. The laser
unit will also automatically power off if it is left in Sleep Mode for
8 hours.
REMOTE CONTROL: MANUAL MODE BUTTON
To activate Manual Mode, press and hold the remote control
manual mode button (H) for 3 seconds. Manual Mode must be
activated to use manual sloping. (Refer to Using Manual Slope
Mode for a complete description of this function.)
To re-engage full self-leveling, press and hold the manual button
again for 3 seconds.
Using Manual Slope Mode:
The DW078 Manual Slope Mode allows the self-leveling
function to be disabled in one axis (direction) so that the
laser can be sloped in that axis. The other axis will continue
to self-level, ensuring that the laser beam is only sloping in
the expected direction.
Entering and exiting Manual Slope Mode:
• To activate manual sloping mode, press and hold the
remote control manual mode button (H) for 3 seconds.
• To re-engage full self-leveling, press and hold the
manual button again for 3 seconds.
Setting the Slope Direction:
• When Manual Slope Mode is activated, the unit
automatically engages Manual Y Mode. This allows the
operator to slope the laser in the direction of the Y-axis,
as indicated by the "gunsights" on the roll cage.
In certain situations, it may be desirable to slope the
laser in the X-axis. The direction of Manual Slope Mode
can be changed back and forth between the Y- and
X-axes as follows:
• Immediately (within 5 seconds) after entering Manual
Slope Mode, press and hold the remote control right
arrow button to activate Manual X Mode.
• The unit can be changed back to Manual Y Mode
by immediately pressing and holding the remote
control left arrow button.
• To change the direction of Manual Slope Mode at a
later time, re-engage full self-leveling, then activate
Manual Slope Mode again and go through the axis
selection procedure outlined above.
The X and Y LED indicator lights on the laser unit control panel
(Fig. 3, E, F) will indicate the manual slope direction that
is selected. The manually controlled axis is identified by a
turned-off LED, and the self-leveling axis is identified by a
lighted LED.
Setting the Amount of Slope:
Once Manual Slope Mode is activated, the amount
of slope can be manually adjusted using either of the
following methods:
• Use the remote control up and down arrow buttons
(Fig. 3, I) to tilt the laser rotor head up and down.
OR
• The entire laser unit can be tipped up and down by
setting it on a sloped surface. Make sure the laser unit is
positioned so the direction of manual sloping is lined up in
the same direction as the sloped surface.
10