DeWalt DW078 Guide D'utilisation page 16

the latch (Y) on the clamp pops into the latch hole (Z) on the
detector.
2. Open the jaws of the clamp by turning the clamp knob (AA)
counterclockwise.
3. Position the detector at the height needed and turn the clamp
knob clockwise to secure the clamp on the rod.
4. To make adjustments in height, slightly loosen the clamp,
reposition and retighten.
FIG. 11
Z
W
U
X
Detector Cleaning and Storage
• Dirt and grease may be removed from the exterior of the
detector using a cloth or soft, non-metallic brush.
• The D WALT Digital Laser Detector is waterproof. If you should
E
drop the detector in mud, wet concrete, or a similar substance,
simply hose the detector off. Do not use high-pressure water,
e.g., from a pressure washer.
V
Y
AA
• The best storage place is one that is cool and dry—away from
direct sunlight and excess heat or cold.
Detector Service
Except for batteries, there are no user serviceable parts in the
Digital Laser Detector. Do not disassemble the unit. Unauth orized
tampering with the laser detector will void all warranties.
Detector Troubleshooting
THE DETECTOR WILL NOT TURN ON.
• Press and release the power/volume button.
• Check to see that the battery is in place and in the proper
position.
• If the detector is very cold, allow it to warm up in a heated
area.
• Replace the 9-volt battery. Turn the unit on.
• If the detector still does not turn on, take the detector to a
D WALT service center.
E
THE DETECTOR'S SPEAKER MAKES NO SOUND.
• Ensure that the detector is on.
• Press the power/volume button. It will toggle from high, to low,
to mute.
• Ensure that the rotary laser is spinning and that it is emitting a
laser beam.
• If the detector is still not making any sound, take it to a D
service center.
THE DETECTOR DOES NOT RESPOND TO A STATIONARY
LASER BEAM.
• The D WALT Digital Laser Detector has been designed to work
E
only with rotary lasers.
14
WALT
E