EUROM RAD 500 Manuel D'utilisation page 20

Turbo:
The RAD 2000T is fitted with an extra ceramic heating element (400W) with an integral fan
that can blow warm air into the room. Activate this Turbo by pressing the turbo switch on
(I) the lamp lights. Stop it by pressing the turbo switch off (0); the lamp
 To switch off, turn the power switch to off (O). The heater switches off. Unplug.
 Note! It takes a long time for an oil filled radiator to cool down. Give the radiator sufficient
time to cool down before touching or moving (use handle!).
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the appliance if
it inadvertently falls over. When the heater is returned to its upright position, it will resume
functioning as normal but, before reusing, switch off, unplug and check for damage. Do not
use the heater if it is damaged or malfunctioning, but have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it or cannot draw in enough fresh
air. As mentioned above, this is generally caused by (partially) covering the heater,
obstructing the air intake and/or outlet grills or installing the heater too close to a wall or
something similar. When the overheating safeguard has switched the heater off, you need
to set the power switch to 'O' (off) and unplug the heater. Give the heater time to cool down,
remove the source of the overheating and use as normal. If the problem persists or if you
have not been able to trace the source of the overheating, turn the heater off immediately
and unplug. Contact a service point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug
from the socket and allow the heater to cool down before cleaning or carrying out
maintenance work.
 Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!
 Carefully use a vacuum cleaner to remove dust and dirt from the grills.
 The heater contains no other parts which need maintenance.
 At the end of the season, store the cleaned heater in the original packaging if possible.
Store upright in a cool, dry and dust-free place.
 Do not dispose of heater with household waste when if becomes worn or damaged
beyond repair. Take it to your local authority's collection point for electrical appliances
where any reusable materials will be collected and redistributed.
extinguishs.