EUROM RAD 500 Manuel D'utilisation page 18

Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
21. Keep the heater clean. Dust, dirt and/or a build-up of deposits in the heater are a
common cause of overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the appliance, cord or
plug, if the appliance is malfunctioning, if it has been dropped or if there are signs of
any other defect. Return the complete product to the vendor or to a certified electrician
for inspection and/or repair. Always ask for original parts.
23. The heater is filled with special oil. Repairs that involve opening the oil containers may
only be carried out by the manufacturer or one of its service points. Consult them if you
suspect an oil leak.
24. Do not use attachments and/or accessories that have not been recommended or
supplied by the manufacturer.
25. The appliance (incl. cord and plug) may only be opened and/or repaired by properly
authorised and qualified persons.
26. Only use this heater for its intended purpose, and as described in this instruction manual.
Not abiding by instructions 24, 25 and 26 may lead to damage, fire and/or personal injuries.
A failure to adhere to these rules also immediately nullifies the guarantee and vendor,
importer and/or manufacturer do not take responsibility for any of the consequences!
Installation, Location and Connection
Remove all packaging material and keep out of reach of children. After removing packaging,
check the appliance for damage or other signs that could indicate a fault/defect/malfunction.
In case of doubt, do not use the appliance, but contact your vendor for inspection or
replacement.
before it has been installed in accordance with the following instructions!
RAD 500:
Firmly slide the legs supplied over the front
panel or the rear fin, as illustrated. Then firmly
tighten the screws.
RAD 1500 en RAD 2000:
 Screw the 2 x 2 swivel castors with the 4 capped nuts onto the ends of the two wheel
supports. The wheels should be at the hollow side!
 Turn the radiator upside-down (make sure you don't scratch the paint or the floor!)
Do not use the heater