Cleaning Metal Grease Filters - Faber INCA LUX Série Instructions D'installation

Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent solution or
washed in the dishwasher. They should be cleaned every 2 months
• Remove grease filters.
use, or more frequently if use is particularly heavy.
• Open the Panel by pulling it.
• Remove the filter, pushing the lever towards the back of the unit
and at the same time pulling downward.
• Wash the filter without bending it, leave it to dry thoroughly before
replacing (if the surface of the filter changes color over time, this
will have absolutely no effect on its efficiency).
• Replace, taking care to ensure that the handle faces forward.
• Screw the Frame into place
• Cleaning in dishwasher may dull the finish of the metal grease
filter.
• Close the Panel.
• No water can be present in filters before installing back in hood.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable and cannot
be regenerated, and must be replaced approximately every 4
months of operation, or more frequently with heavy usage.
• Open the Panel by pulling it.
• Remove the Filter, pushing it towards the back of the unit and
at the same time pulling downward.
• Remove the saturated Activated Charcoal Filters, as indicated
(A).
• Fit the new Filters, as indicated (B).
EN
• Replace, taking care to ensure that the handle faces forwards.
• Close the Panel.
Caution: "When used in recirculation mode, to Reduce
the Risk of Fire and Shock use only conversion kit Model
FILTER 1 or FILTER1LL"
Lighting unit
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into
the housings on the lamp holder.
fixing pin lever.
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
A
B
a
b
Gu10 self-ballasted led lamps
– listed in accordance with ul
1993/nmx-j-578/1-ance/csa
c22.2 No. 1993
a
b
13