Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent
solution or washed in the dishwasher. They should be
cleaned every 2 months, or more frequently if use is par-
ticularly heavy.
• Remove the filter, pushing the lever towards the back of
the unit and at the same time pulling downward.
• Wash the filter without bending it, leave it to dry thorou-
ghly before replacing (if the surface of the filter changes
color over time, this will have absolutely no effect on its
efficiency).
• Replace, taking care to ensure that the handle faces
forward.
• Cleaning in dishwasher may dull the finish of the metal
grease filter.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and should be replaced
approximately every 4 months of operation, or more
frequently with heavy usage.
• Remove the charcoal filter by rotating it clockwise (back-
wards) until it unlocks from the motor housing and pull
off sideways.
• To re-insert each charcoal filter, place up against the side
of the blower and push it inward. Then turn the charcoal
filter clockwise (forward) until it fits into place.
Replacing the two 35W Halogen GU10 bulbs
• Turn off electrical supply before replacing bulbs, and make
sure bulbs are cool to touch before proceeding.
• Carefully remove the snap-on lamp cover using a flat head
screwdriver by levering it down from under the metal ring.
• After the snap-on lamp cover is down remove the halogen
lamp at the base and turn slightly to the left and the pull
out from the connector and turn slightly to the left.
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into the
housings on the lamp holder.
• Replace the snap-on lamp cover.
• Once the bulb pins are in place turn slightly to the right
to secure.
14
1
2
Publicité
Table des Matières
