Technical Data; Description - Dal Zotto SILLA Manuel Utilisateur

TECHNICAL DATA

Definition in according to:
Constructive system
Nominal thermal power in kW
Efficiency in %
smoke outlet diameter in mm
Chimney height ≥ (m) - dimension (mm)
Depression by rating calorific value in Pa - wood
Hourly wood consumption in Kg / h (wood with 20% humidity)
CO measured at 13% oxygen in %
Exhaust gas emission in g/s - wood
Exhaust gas temperature in °C - wood
Hearth opening size in mm (W x H)
Hearth size in mm (W x H x D)
Oven size in mm (W x H x D)
Type of grill
Height in mm
Width in mm
Depth in mm
Weight in kg
fire prevention safety distances
m riscaldabili (30 kcal/h x m
3
(*) The proposed value are indicative. The installation must, in any case, be sized and verified according to the general calculation method in UNI
EN13384-1 or by another method of proven efficiency.
(**) For those buildings in which the thermal insulation does not correspond to the instructions on heat protection, the heating volume of the product
is: favourable type of building (30 kcal/h x m
With thermal insulation in accordance with the regulations regarding energy saving, the heated volume is greater. With temporary heating, in
the event of interruptions which last more than 8 hours, the heating capacity is reduced by about 25%.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and wood
moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific adjustments
on the appliance could be needed.

DEsCRIPTION

The chimney stoves of DAL zOTTO are suitable to heat living spaces for some periods.
As fuel, wood logs are used. The appliance works as an intermittent operating appliance.
The stove is made of sheets in galvanized and painted steel, of cast iron (grate and grate holder of the hearth, exhaust pipe). The hearth is
totally sheathed with cast-iron single sheets and refractory material. Inside there are a easy extractable thick flat grate and its holder. The
combustion chamber is hermetic welded and is sheathed with a painted steel carter.
The inside smoke plate made of vermiculite, reflects the fire radiation and increases the internal temperature of the combustion chamber. This
process together with the exhaust gases flows, makes optimal the combustion and improves the efficiency.
The hearth is equipped with a panoramic door with ceramic glass (resistant up to 700 °C). This allows a wonderful view on the burning flames.
Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth door will be found an extractable ash-drawer with a closing door
ACCEssORIEs
The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of the stove, the heat
is radiated into the environment.
The stove is equipped with controls of primary and secondary air by which it is adjusted the combustion air.
1A - PRIMARY air register (Picture
With the primary air control (movable valve), which is found below the hearth door it is adjusted the passage of air through the ash drawer
and the grate in the fuel direction. The primary air is necessary for the combustion process. The ash drawer must be regularly emptied, so
that the ash does not obstruct the primary air entry. Through the primary air the fire is also kept alive. Primary air is also necessary to keep
fire live.
During the combustion of wood, the primary air register must be opened only a few, since otherwise the wood burns quickly and the device
can overheat (see chapter NORMAL OPERATION).
20
)
3
); less favourable type of building (40 kcal/h x m
3
POKER
sERIEs
6)
); unfavourable type of building (50 kcal/h x m
3
8).
(Picture
GLOVE
sERIEs
ENgLIsH
sILLA
EN 13240
1
6,6
82
120
4 - 200x200 Ø200
12 ( 1,2 mm H O)
2
1,8
0,07 % - mg/m
3
5,1
258
220 x 215
228 x 365 x 278
/
Movable - flat
832
412
412
77
Chapter FIRE sAFETY
190
).
3