Metabo HPT WR 36DA Instructions De Sécurité Et Mode D'emploi page 17

NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
9. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 5. It is
indicated by green lamp. (Fig. 19)
To prevent the battery power consumption, turn off the
LED light frequently.
Switch panel
Light section Light indicator
switch lamp
Always-ON
mode
Panel
display
Always ON
(turn off after
State
2 minutes)
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
Fig. 19
Table 5
SW Always-OFF
interlocked mode
mode
Light only Always OFF
SW-ON
10. Tightening mode selector function (Fig. 20)
CAUTION
● Do not subject the switch panel to shock or
damage.
● Select tightening mode while the trigger switch
is released. Failure to do so could result in
malfunction.
Tightening mode
selector switch
Tightening mode
indicator lamp
(1) Tightening mode selector switch
By using the Tightening mode selector switch, the
tightening torque can be adjusted according to the type
of work.
The Tightening mode switches between 4 diff erent modes
each time the Tightening mode selector switch is pressed.
NOTE
○ The appropriate mode diff ers depending on the bolt
and the material being screwed. Tighten in a few test
bolts and adjust the mode setting accordingly.
○ The tightening mode selector switch can only be set
after the battery has been installed in the wrench and
the trigger switch has been pulled once.
English
Fig. 20
17