Metabo HPT WR 36DA Instructions De Sécurité Et Mode D'emploi page 15

● <WR36DB>
(1) Align the square portions of the socket and the anvil
with each other.
(2) Make sure to fi rmly install the socket by pushing it all
the way into the anvil.
(3) When removing the socket, pull it out of the anvil.
Hexagonal socket
3. Confi rm that the battery is mounted correctly.
4. Check the rotational direction
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the pushing button.
The L-side of the pushing button is pushed to turn the
bit counterclockwise. (See Fig. 14). (The
marks are engraved on the body.)
marks
Push
CAUTION
The pushing button can not be switched while
the impact wrench is turning. To switch the
pushing button, stop the impact wrench, then set
the pushing button.
5. Switch operation
○ When the trigger switch is depressed, the tool rotates.
When the trigger is released, the tool stops.
○ The rotational speed can be controlled by varying
the amount that the trigger switch is pulled. Speed
is low when the trigger switch is pulled slightly and
increases as the trigger switch is pulled more.
○ When releasing the trigger of the switch, the brake will
be applied for immediate stopping.
Anvil
Fig. 13
and
marks
Push
Pushing button
Trigger switch
Fig. 14
NOTE
A buzzing noise is produced when the motor is about
to rotate; this is only a noise, not a machine failure.
6. Tightening and loosening bolts
A hex. socket matching the bolt or nut must fi rst be
selected. Then mount the socket on the anvil, and grip
the nut to be tightened with the hex. socket. Holding
the wrench in line with the bolt, press the power switch
to impact the nut for several seconds.
If the nut is only loosely fi tted to the bolt, the bolt
may turn with the nut, therefore mistaking proper
tightening. In this case, stop impact on the nut and
hold the bolt head with a wrench before restarting
impact, or manually tighten the bolt and nut to prevent
them slipping.
7. Using the hook
You can use the hook to briefl y set aside the tool
during operation.
You can change the hook's position to the left or right.
WARNING
● The hook is not for hanging the tool on your
person.
To avoid injury, do not hang the tool from your
belt, trousers or any other part of your body.
● Do not use the hook in high places.
Doing so could result in unexpected accidents
such as dropping the tool.
● When using the hook, make sure the tool is
placed in a stable location where it won't slip off
or be dislodged by wind.
CAUTION
Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
English
Hook
Fig. 15
15