Driveline; Driveline With Adjustable Plate Clutch - breviglieri Zappatrice b25s-85 Manuel D'utilisation Et D'entretien

Before beginning work, make sure that the machine is in order, that the lubricating oils are at the right level and that all parts
subject to wear and deterioration are fully efficient. Also make sure that the guards are correctly positioned.
Adjustments and operations required to prepare the machine for work must always be carried out with the machine off

4.1.1 DRIVELINE

The driveline is a mechanical component. When it is operating it can be a source of danger to the physical well-being of
those who work with it. Take the greatest care when carrying out operations that involve the driveline. Carefully read the
instruction manual supplied with the driveline. If you have doubts about the way it operates, if it is without its shields, worn
or broken, replace it with a new driveline that possesses the same characteristics and bears the «CE» mark.
Never modify or adapt the driveline in any way.
If the length must be adapted, work with the utmost care so as to keep the telescopic
tubes coupled to the maximum extent. With the exception of length adaptation, it
is forbidden to modify the driveline. If this is necessary, contact the Manufacturer.
Take the greatest care when inserting the driveline. Make sure that it is well locked
on both the tractor's PTO and on the machine. Also comply with the indications in the
instruction manual supplied with each driveline. Make sure that the driveline shield,
fastened with the relative chains, is free to turn without obstruction. Also check the
guards on both the tractor and implement. If they are not in a perfect condition,
they must be immediately replaced with new protections. It is very important for the
protective guards to overlap the driveline shields by at least 5 cm on both sides.
When the driveline is fully extended, in all work conditions, the telescopic tubes must
overlap to at least 1/3rd of their length (A Fig. 4).
When the driveline is fully inserted, the play must be at least 4 cm (B Fig. 4). Contact the Manufacturer's Technical Service if this
is not possible.
Before engaging the PTO, make sure that its rotation speed corresponds to the rate for which the machine has been desi-
gned.

4.1.2 DRIVELINE WITH ADJUSTABLE PLATE CLUTCH

The driveline has a safety clutch to protect the transmission components of the machine against stress and excessive overloads.
The clutch is calibrated for medium-duty use. If it slips during work, all the nuts that hold the springs must be evenly tightened by
half a turn and the operation of the device checked after about 200 meters of work. Repeat the operation if necessary. The clutch
must be adjusted by unscrewing the nuts if it is blocked.
25
s
b
«Section 2» about safety.
DANGER
and blocked.
DANGER
DANGER
CAUTION
- 25 -
macchine agricole
Fig. 4