Eliminating Of The Machine; Section 5; Routine Maintenance; Lubrication - breviglieri Zappatrice b25s-85 Manuel D'utilisation Et D'entretien

macchine agricole
If the machine is to remain idle for a long period of time, lubricate the parts subject to wear and store it in a dry, sheltered
place, covered with a plastic sheet. This will ensure that the machine is in an ideal condition when required again.

4.6.2 ELIMINATING OF THE MACHINE

At the end of the operating life of the machine (or when it becomesobsolete), before carrying it in an authorized center, to make
surethat not there is oil in multiplying or in the hydraulic system (incase present), to the aim to avoid highly polluting dispersions
forthe atmosphere. Is necessary to inquire itself near the competentlocal authorities by the procedure to follow, always in the
respectof the national laws.

SECTION 5

Maintenance

5.1 ROUTINE MAINTENANCE

The various routine maintenance operations are described below. Remember that lower running costs and long machine life
depend on continual compliance with these instructions.
Before proceeding with any operation, make sure that the machine is parked on a flat surface. Prevent it from moving by
placing chocks under the wheels.
Servicing, adjusting and the operations required to prepare the machine for work must be carried out with the tractor and
the driveline detached from the machine.
The servicing frequencies indicated in this manual are indicative and refer to normal conditions of use. They may therefore vary
depending on the type of service, whether the environment is dirty or not, seasonal factors, etc.
The servicing operations must obviously be carried out more frequently in heavier duty service conditions.
Before injecting lubricating grease into the grease nipples, carefully clean the unions to prevent mud, dust or foreign bodies
from mixing with the grease as this would reduce or even annul its lubricating effects.
Injection into the greasing points of a large quantity of grease at high pressure can damage the bearing protection.
Carefully read the warnings and precautions on the lubricant containers.

5.2 LUBRICATION

Lubrication of any machine with parts that turn and/or rub together is a vitally important task for the life and functionality of the
actual machine itself. Lubrication must therefore be carried out systematically and at the required intervals. The frequencies given
This operation must therefore be carried out with due care.
Lubricate and grease all the required points.
Use oil of the recommended type for topping up and changes.
Keep all lubricants well away from children's reach.
The operator should thoroughly wash himself after using lubricants.
Dispose of used oil in compliance with the anti-pollution laws.
25
s
b
CAUTION
WARNING
CAUTION
DANGER
- 30 -