Before Use; Driveline - breviglieri mekfarmer K 270 Manuel D'utilisation Et D'entretien

The surface on to which the machine is to be loaded must be perfectly horizontal, to prevent the load from shifting.
Once the machine has been moved on to the truck or wagon, make sure that it remains blocked in position.
▪
Fix the machine firmly to the surface on which it rests by means of the pre-engineered points marked with the «hook» de-
cal, using well tightened ropes or chains suited to its weight and able to prevent it from moving in any way.
▪
After having transported the machine to the desired site and before removing the elements that hold it in place, make sure
that its position is unable to be of danger.
▪
Now remove the ropes and unload the machine from the means of transport in the same way as it was loaded.
SECTION 4
Instructions for use

4.1 BEFORE USE

Before he sets the machine at work, the operator must have read and understood all parts of this manual and particularly
Before beginning work, make sure that the machine is in order, that the lubricating oils are at the right level and that all parts
subject to wear and deterioration are fully efficient. Also make sure that the guards are correctly positioned.
Adjustments and operations required to prepare the machine for work must always be carried out with the machine off

4.1.1 DRIVELINE

The driveline is a mechanical component. When it is operating it can be a source of danger to the physical well-being of
those who work with it. Take the greatest care when carrying out operations that involve the driveline. Carefully read the
instruction manual supplied with the driveline. If you have doubts about the way it operates, if it is without its shields, worn
or broken, replace it with a new driveline that possesses the same characteristics and bears the «CE» mark.
If the length must be adapted, work with the utmost care so as to keep the telescopic tubes coupled to the maximum extent.
With the exception of length adaptation, it is forbidden to modify the driveline. If this is necessary, contact the Manufac-
turer. Take the greatest care when inserting the driveline. Make sure that it is well locked on both the tractor's PTO and on
the machine. Also comply with the indications in the instruction manual supplied with each driveline. Make sure that the
driveline shield, fastened with the relative chains, is free to turn without obstruction. Also check the guards on both the
tractor and implement. If they are not in a perfect condition, they must be immediately replaced with new protections. It is
very important for the protective guards to overlap the driveline shields by at least 2" inch on both sides.
mekfarmer
CAUTION
WARNING
«Section 2» about safety.
DANGER
and blocked.
DANGER
DANGER
Never modify or adapt the driveline in any way.
- 25 -
K 270
macchine agricole