Cleaning And Maintenance; Ce-Statement - EUROM SF1503T Manuel D'utilisation

In case of internal overheating, the overheating safeguard will switch the heater off. This may occur if the heater
cannot give off enough heat or if it cannot draw in enough fresh air. As mentioned above, this is generally caused
by (partially) covering the heater, obstructing the air intake and/or outlet grills or installing the heater too close to a
wall or something similar. When the overheating safeguard switches the heater off, set the mode selector dial to
„0‟ (off), unplug and allow the heater to cool down. Remove and/or amend the cause of overheating and use
again, as normal. If you cannot find a cause and overheating recurs, stop using the heater, and take it in for
inspection/repair.

Cleaning and Maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of overheating so these
should be removed regularly. Switch off the heater, remove the plug from the socket and allow the heater to cool
down before cleaning or carrying out maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps,
sprays, cleaners or abrasives, waxes, polishes or chemical solutions!

Using a vacuum cleaner, carefully remove any dust and dirt from the grills and ensure that the air intake and
outlet openings are clean. Be careful not to touch or damage any internal parts during cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if necessary. Store it upright in a
cool, dry and dust-free place.

Do not dispose of heater with household waste when it becomes worn or damaged beyond repair. Take it to
your local authority's collection point for electrical appliances where any reusable materials will be collected
and redistributed.

CE-statement

Euromac bv., Genemuiden-NL hereby declares that the EUROM fan heater with PTC-elements, type
SF1503T, complies with the LVD guideline 2006/95/EC and the EMC guideline 2004/108/EC and meets the
following standards:
EN 60335-1:2002+A1+A11+A12+A2+A13
EN 60335-2-30:2003+A1+A2
EN 62233:2008
Genemuiden, 09-05-2011
W.J. Bakker
EN 55014-1:2006
EN 55014-2:1997+A1
EN 61000-3-2:2006
EN 61000-3-3:1995+A1+A2
11