Putting The Model Into Operation - df models Brushless SpeedHammer 4WD RC Monster Truck 1/8 Notice D'utilisation

Dual rate control steer angle (i)
The deflection of the servo steering can be set in the range of 0% to 100%. This setting affects both the steering directions,
to the right and left equally.

. Putting the model into operation

The model is already assembled ready to run and can be put into operation immediately after the rechargeable batteries for
the transmitter and the rechargeable drive battery are charged. The drive and steering components are assembled and wired,
and the link between the transmitter and receiver is established automatically each time after they are switched on.
Charging the rechargeable drive battery
Two 2S LiPo batteries are provided for model operation (not included in the scope of delivery).
We recommend using our 7.4 LiPo battery with 3400 mAh, no. 1800
Charge the batteries outside the model to avoid overheating during the charging process.
Please observe the user's manual of the charger used as well as the manufacturer's information for the
batteries. Please observe the safety instruction in this manual!
Put the charged drive battery into the model
> Undo the cotter pins for the battery mounting devices and
> take off the covers.
> Insert the drive batteries into the battery holder facing backwards.
> Replace the covers and
> re-secure them with the cotter pins.
Make a visual check of the model.
> Are the wheel lugs and screw connections tightened snugly?
> Is the servo control lever attached snugly on the servo shaft?
> Is the rechargeable drive battery charged and fixed in the mounting device?
> Do the rotating and moveable parts moved smoothly?
> Are the cables installed and secured such that they cannot get into the moving parts?
> Are the threaded rings for the spring preload adjusted the same on both sides of an axle?
Check the range of the remote-control transmitter and of the control functions.
CAUTION!
Never operate the model with a remote control unit operating in a faulty manner.
Range of the remote-control transmitter
To maintain secure control over the model, before each start and especially after a crash, you should check the functioning
and range of the RC system. Testing the functioning of the steering servo will suffice to do so.
If the remote-control system should not work acceptably, check the charging level of the rechargeable batteries for the trans-
mitter and receiver and refresh the link between the transmitter and receiver.
> Prop up the model such that the wheels are suspended freely in the air. Due to the static friction of the tyres on the ground,
the steering would react too slowly if not suspended.
> Go about 50 m away from the propped up model.
> Test the steering function as described below.
Control function of steering
> Put the steering wheel and the respective trimming in the neutral position.
> Switch on the transmitter.
> Connect the rechargeable battery to the electronic speed controller and switch on the receiver.
> Turn the steering wheel to the left and the right. The wheels of the model should also turn to the left and the right.
If the wheels turn in the opposite direction, put the reverse switch for the steering function on the transmitter in the other
position.
> When you release the steering wheel, the wheels should turn back into the straight-ahead position.
> If the wheels are not exactly straight in the zero position of the steering wheel, correct the position on the trim control for
the steering function (channel 1).
> The end stops of the steering wheel should actuate the end stops to the right/left of the steering!
-  -
3221/V1/0710