Makita HU01 Manuel D'instruction page 16

Place the undercover so that the symbol
undercover is aligned with the symbol
locking lever.
010902
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
1
2
010903
At this time, make sure that the locking lever fits in the
groove in the undercover.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
1
010887
Remove the base frame and place the tool upside down.
CAUTION:
Before placing the tool upside down, be sure to
•
remove the base frame (only for Model UM164D).
on the
on the
on
1. Groove in the
undercover
2. Locking lever
1. Blade cover
16
2
1
3
4
010888
To remove the shear blade, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
010889
Take out the undercover, shear blade and crank in order
from the tool.
1. Storage case
011043
NOTE:
In the 2-way usage, the removed hedge shear
•
blade need to be sheared in the blade storage
case and then stored for future use.
1. Undercover
2. Locking lever
3. Press
4. Turn
on the undercover
on the locking lever.
1. Undercover
2. Shear blade
3. Crank
1
2
3
1