Optional Accessories - Makita HU01 Manuel D'instruction

1
010910
Tighten two screws with a coin or similars firmly.
1
2
010911
Place the undercover so that the symbol
undercover is aligned with the symbol
locking lever.
010912
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
1
2
010913
At this time, make sure that the locking lever fits in the
groove in the undercover.
CAUTION:
Never use the
•
undercover on it.
1. Screws
1. Locking lever
2. Undercover
1. Groove in the
undercover
2. Locking lever
tool without installing
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
Storage
1
010914
The hook hole in the tool bottom is convenient for
hanging the tool from a nail or screw on the wall.
Put the blade cover on the shear blades so that the
on the
blades are not exposed. Store the tool out of the reach
on the
of children carefully.
Store the tool in the place not exposed to water and rain.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These
•
recommended for use with your Makita tool
specified in this manual. The use of any other
on
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Hedge shear blade cover
•
Hedge shear blade assembly
•
Chip receiver for hedge trimming
•
Makita genuine battery and charger
•
For cordless grass shear use
This tool can be used as a grass shear by using the
grass shear blade (optional accessory) and 2-way
change set.
To use this tool as a grass shear, replacing the hedge
shear blades with the grass shear blades is required.
the
For removing the hedge trimmer blades, refer to the
aforementioned section titled "Removing the hedge
shear blades".
13
1. Hook hole
accessories or attachments
persons. Only use
are
accessory or