Oceanic OCEACLIM140W Guide D'utilisation page 54

-
Please remove the plug of the secondary
drainage port.
-
Connect the opening to a fitting drainage pipe
(not provided)
-
Extend the pipe to a bucket or a drainage ditch
-
Switch the appliance on
With this setup in place, all water produced during operation will be drained out
continuously.
If automatic drainage is not employed, please ensure to secure the secondary
drainage port with the plug provided.
2. Manual drainage via lower drainage port (primary drainage port)
This manual procedure is needed if automatic drainage detailed above is
not employed.
-
Place the appliance near a drainage ditch
-
Remove the plug of the primary drainage port
-
Tilt the appliance slightly to pour water out
-
Re-plug the primary drainage port after drainage
Appliance not in use
-
Perform water drainage as instructed above.
-
Turn on the fan for a few hours to dry the inside of the appliance. It
dehumidifies the inside of the appliance, and thus prevents the formation of
any mould.
-
Stop the appliance and take the power supply plug out. Then take out the
battery of the remote control and store the appliance properly.
-
Clean the air filter and reinstall it.
-
Remove the air hoses, store them properly, and cover the holes tightly.
No manual drainage work
53
is needed after use.