Oceanic OCEACLIM140W Guide D'utilisation page 50

B. Operation principles of each mode:
1. Automatic mode
When the Automatic mode
automatically operates and selects the operation mode Cool
depending on the room temperature.
-
If the room temperature is the same as or above 24°C, the appliance will
run in Cool mode
-
If the room temperature is under 24°C, the appliance will run in Fan mode
.
2. Cool mode
When the room temperature is higher than the set temperature, the compressor
will start to run.
When the room temperature is lower than the set temperature, the compressor
will stop but the upper fan will operate at the selected speed.
3. Fan mode
In this operation mode, the selection of temperature is disabled. The upper fan
functions at the preset temperature. The compressor and the fan at the bottom
will not function.
4. Sleep function
The appliance can be put to Sleep function only when it is in Cool mode
Press the button
speed. The set temperature will increase by 1°C after one hour of functioning,
by 2°C after two hours. After six hours, the appliance stops.
Remarks:
The main control board has a memory function. The main control board records
the previous operation mode before the appliance is put to Sleep function.
Consequently, as you restart the appliance, it will work in the previous operation
mode. It needs not to be reprogrammed. This function is not available if the
previous operation mode is
The air conditioner should be used, while under COOL mode or DEHUMIDIFER
function, in locations where windows are closed. Otherwise the water tank will
fill up quickly.
:
.
:
:
to activate this function. The upper fan will function in slow
.
is selected, the temperature sensor
49
or Fan
.