Thermostat - External Chronothermostat; Idle Period (End Of Season) - Cola SPRINT acciaio Série Manuel D'installation, D'utilisation Et D'entretien

Position release
SLOT for inserting control
ROD and SELECTION lock
Position lock
The standard hot air ducting outlet is vertical; on customer request the outlet connection can be turned 90° or 180°
allowing the hot air to exit in the upper rear side or, with the addition of a flexible pipe, in the lower rear side or
towards to the floor.
Any modifications must be done by authorised and competent personnel; changes made at random can
cause serious damage to the stove, for which COLA declines any liability.

4.8 Thermostat - external chronothermostat

The unit controls the room temperature by means of its own digital thermostat whose
function is to detect the temperature through a probe and lower the heat output when
the set temperature is reached.
To use an external thermostat, contact an authorised technician and proceed as
follows:
- turn off the power by means of the main switch on the back and detach the power
cable;
- remove the side panel to access the electronic controller;
- referring to the wiring diagram, connect the two wires of thermostat to the respective
board TERM terminals;
- refit everything and check correct operation.
The setting procedure is as follows:
- external thermostat:
- external chronothermostat: SET the temperature to 7°C and disable the chrono
All the menu functions do not change for each of the settings and signalling of the
connection occurs with lighting up of the segment LED on the status bar of the
display.

4.9 Idle period (end of season)

If the stove is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows
- remove all the pellets from the hopper;
- disconnect the power and remove the power cable;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- protect the stove from dust with suitable covering;
- store in a dry and safe place protected from atmospheric agents.
SET the temperature to 7°C;
functions from the menu 03-01.
56
Control
ROD
4th
reference
3rd
reference
2nd
reference
1st
reference
SPRINT** acciaio