Connection Of Headphones - VINCENT SV-237MK Manuel D'utilisation

CONNECTIONS FOR THE STANDBY CONTROL
Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-
fiers), have two terminals which do not differentiate between input and output. In this case either of
the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected!
All receiving devices must not be connected to more than one preamplifier or integrated amplifier
(directly or indirectly)!
A set of headphones equipped with a 6.3 mm jack can be plugged into the socket "PHONES" (11) on
the front of the appliance.
SV-237MK
By doing this, the loudspeakers are switched off. All headphones with an impedance of between 32 Ohm
and 600 Ohm may be used. Unsuitable headphones with too low impedance may damage the amplifier
or produce such unexpectedly loud volume that your hearing may be damaged. The volume (5)(23) should
be reduced for safety reasons before a set of phones is connected.
38
Vincent
(POWER CONTROL)

CONNECTION OF HEADPHONES