Stopping Drive; Transport Of Vehicle - Reely ROAD Rhino 23 60 49 Notice D'emploi

e) Stopping drive
To stop driving, you proceed as follows:
• Let the vehicle roll to a halt.
• Once the vehicle is stationary, take off the car body and put the on/off switch on the vehicle in the "OFF" position.
Doing this, don't touch the wheels or the drive, under no circumstances move the operating lever for the
drive function on the remote control!
• Separate the drive battery from the cruise control. Loosen the plug-in connection completely.
• Only now must the transmitter be turned off.
Warning!
Motor and drive battery can get very warm during operation and may possibly also get hot. This is why
you should not touch these parts straight after the drive.
Stop driving straight away when you notice unusual responses of the vehicle to the control commands
on the transmitter or when the vehicle no longer responds.
This behaviour could be caused by a weak vehicle battery, weak batteries/rechargeable batteries in the
remote control or by too high a distance between vehicle and remote control.
An antenna that was not pulled out all the way, disturbances on the radio channel used (eg other
models, radio transmissions through other devices) or adverse transmission/reception conditions could
also be a cause for unusual responses of the vehicle.
f) Transport of vehicle
For simple, secure and comfortable transport the buggy is
provided with a carrying strap (1) that is mounted on the
rear.
This makes it possible to carry the model without any prob-
lems with only two fingers.
Figure 6
31