Stopping The Vehicle; Setting The Shock Absorbers - Reely ROAD Micro Breaker Notice D'emploi

i) Stopping the Vehicle
To stop driving, proceed as follows:
• Let go of the throttle/brake lever on the transmitter so that it goes into neutral position, and let the vehicle run out.
• When the vehicle has stopped, take off the body and turn off the speed controller. Never touch the wheels or the
drive mechanism, and make sure you do not move the throttle/brake lever at the transmitter!
Attention!
The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!
• Disconnect the drive battery from the speed controller. Disconnect the plug-in connection completely.
• Now you may turn off the transmitter.
10.

Setting the Shock Absorbers

Front axle
The shock absorbers at the vehicle's front and rear axles can be mounted in different positions at the damper bridge
(1) and at the lower transverse links (2).
At the upper shock absorber end, clips (3) from the delivery for setting the spring-pre-tension can be inserted.
Always set the shock absorbers for one axle evenly (at the left and right wheels of the front or rear axle). Otherwise,
driving behaviour will be influenced negatively.
40
1
3
2
1
3
2
Rear axle