Installation Guide - TEMPUR-PEDIC ERGO EXTEND Manuel Du Propriétaire

installation guide

STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of the
base facing upwards.
STEP 3
To install headboard brackets (sold separately), see instructions
Legs are shipped fully assembled. Alternative heights in 3"
increments can be achieved by removing leg segments.
To install the legs, thread the washer over the bolt of the leg with
the recessed side facing the leg, and tighten by hand. Do not over
tighten.
6 For Tempur-Pedic customer service call: U.S. 1-800-821-6621 | Canada: 1-800-887-4321 | México: 01-722-273-1810
Always use two people when setting up the base.
on page 16-17.
STEP 4
If installing a split unit, see page 15.
Locate the battery backup box and install
(2) 9-Volt batteries (not included).
(For operating instructions see page 13).
STEP 5
Uncoil input power cord (connected to
control box's power port) and plug into
power supply.
STEP 6
Uncoil the power cord and connect to the
power supply. Place power supply on the
ground and extend from the base. Ensure
that the power supply and all attached
cords are directed toward the desired
surge protector.