Installation Guide - TEMPUR-PEDIC UP 2.0 Manuel Du Propriétaire

installation guide

STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of
the base facing upwards.
STEP 3
To install Headboard Brackets (sold separately)
see instructions on page 11.
Legs are shipped fully assembled. Alternative heights in 3"
increments can be achieved by removing leg segments.
To install the legs, thread the washer over the bolt of the leg
with the recessed side facing the leg, and tighten by hand. Do
not over tighten.
6
Always use two people when setting up the base.
For customer support, call Customer Service: 1-800-887-4321
STEP 4
To sync two bases see detailed installation
instructions on pages 9-10.
Locate the Backup Battery Pack and install (4) 9 Volt batteries
(not included).
Store the battery pack in a convenient location for emergency
use.
STEP 5
Uncoil input Power Cord (connected to
motor) and plug into Power Supply.
STEP 6
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure
that the Power Supply and all attached
cords are directed toward the desired
surge protector.