TEMPUR-PEDIC ERGO EXTEND Manuel Du Propriétaire page 21

headboard bracket installation guide (optional)
King/Cal King Headboard Brackets are an optional accessory and are not included.
A 9/16" (14mm) socket wrench and 1/2" (13mm) crescent wrench are necessary to complete installation.
STEP 1
a.) Align the hole in the bracket to the brass sleeve into which the leg
threads. Hold the bracket in place and screw the leg into the base until
it is snug. DO NOT OVERTIGHTEN. Too much force may cause the leg to
spin freely.
b.) Align the tab with the hole in the frame (located towards the foot of the
base) and use a short bolt and nut to secure the bracket. Make sure
the bolt is tight.
STEP 2
Attach the plastic spacer and T-Bracket.
a.) Measure the distance between the mounting holes on the headboard
and install the spacer and attachment plate to accommodate the
headboard.
b.) To install the plastic spacer and attachment plate, you will need (2)
long bolts and (2) nuts. Place the spacer and attachment plate in the
desired location and slip the bolts through the holes with the head of
the bolt facing outward. Position the bolts diagonally on the spacer.
Use the 9/16" (14mm) socket wrench and 1/2" (13mm) crescent
wrench to tighten the bolts.
STEP 3
You may now connect your headboard to the attachment plates using the
remaining short bolts and nuts to secure it to the brackets. The heads of
the bolts will face outward. Use the 9/16" (14mm) socket wrench and 1/2"
(13mm) crescent wrench to tighten the bolts.
Supports De
Tête De Lit
T-Equerre
Espaceur
Écrou
Boulong
Long
17