Storage; Storing Chain Saw; Technical Data; Mt 8200 - Efco MT 7200 Manuel D'utilisation Et D'entretien

en

Storing Chain Saw

WARNING: Stop engine and allow to cool, and secure the unit before storing or transporting
in a vehicle. Store unit and fuel in an area where fuel vapors cannot reach sparks or open
flames from water heaters, electric motors or switches, furnaces, etc. Store unit with
all guards in place. Position so that any sharp object cannot accidentally cause injury to
passersby. Store the unit out of reach of children and other unauthorized persons.
1. Drain and clean the fuel tank in a well ventilated area.
2. Drain all fuel from tank into a container approved for gasoline. Run engine until it stops. This will remove all
fuel-oil mix which could become stale and leave varnish and gum in the fuel system.
3. Clean all foreign material from the saw. Keep away from corrosive agents such as garden chemicals and
de-icing salts.
4. Abide by all Federal and local regulations for the safe storage and handling of gasoline. Excess fuel should
be used in other 2-cycle engine powered equipment.
CAUTION: It is important to prevent gum deposits from forming in essential fuel system
parts such as the carburetor, fuel filter, fuel hose, or fuel tank during storage. Alcohol blended
fuels (called gasohol or E10 or using ethanol, methanol) can attract moisture which leads to
fuel mixture separation and formation of acids during storage. Acidic gas can damage the
engine.
ENGINE:
Displacement:
Bore:
Stroke:
PERFORMANCE:
Idle Speed:
WOT (With Bar & Chain):
Power:
MT 7200 and MT 8200
FUEL AND OIL SYSTEMS:
Carburetor:
Fuel Tank Capacity:
Fuel Mix:
Oil Tank Capacity:
Chain Lubrication:
IGNITION SYSTEM:
Spark Plug:
Spark Plug Gap:
36

STORAGE

TECHNICAL DATA

MT 8200

4.9 cu. in (80.7 cc)
2.0 in (52 mm)
1.5 in (38 mm)
2,700 ÷ 3,000 RPM
12,000 ÷ 12,500 RPM
6.0 HP/4.4 kW (9,000 RPM)
Multi Position Diaphragm Carburetor
27.1 oz. (800 ml)
See Operation-Fueling Section
15.2 oz. (450 ml)
Automatic Speed Controlled Positive Displacement Pump
NGK BPMR8Y
0.02 in. (0.5 mm)
MT 7200
4.3 cu. in (70.8 cc)
1.97 in (50 mm)
1.42 in (36 mm)
2,700 ÷ 3,000 RPM
13,000 ÷ 13,500 RPM
5.4 HP/4.0 kW (9,000 RPM)