SCS Sentinel OpenGate 3 SAFETY Manuel D'installation Et D'utilisation page 62

EN
> FIXATION OF THE MOTOR.
The motor is positioned at the same side as the desired opening direction, see diagram below.
There are several ways in which you can install the motor:
In order to know how best to install your motor,,
Measure the distance
If is less than 5cm: installation is impossible.
A
If is more than 6cm: the motor can be installed
A
at ground level
If is more than 9cm: The motor can be installed
A
at ground level or using a fi xing plate.
Any installation is only ever possible on a fl at,
stable fl oor. (Concrete etc.)
Create a small trench in order to run the
cables without raising the fl oor level.
EN ::: 20
MOTOR
A
from the ground to the upper edge of the reinforcing bar of your sliding
open
MOTOR
GATE
open
Distance A
rein-
forced
Barre de
bar
renfort
concrete fl oor Sol en béton